Difference between revisions of "SuSE Linux Enterprise Desktop using XGL with NVidia"
From Blue-IT.org Wiki
(→Configure XGL as default Desktop) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 29: | Line 29: | ||
modprobe nvidia | modprobe nvidia | ||
| − | Now you can start sax2 | + | Now you can start sax2 to configure your xserver: |
sax2 -m 0=nvidia | sax2 -m 0=nvidia | ||
| − | After you finished | + | After you finished start your xserver by switching back to runlevel five: |
init 5 | init 5 | ||
| + | |||
===Configure XGL as default Desktop=== | ===Configure XGL as default Desktop=== | ||
Look at | Look at | ||
| Line 40: | Line 41: | ||
Using YaST, you have to look at the bottom in the sysconfig editor to find the appropriate field. | Using YaST, you have to look at the bottom in the sysconfig editor to find the appropriate field. | ||
| + | |||
| + | [[Category:Opensuse]] | ||
Latest revision as of 20:01, 8 January 2012
Contents
Troubleshooting
To activate Xgl you have to follow a few aspects. Additional Informations you find at Xgl unter SUSE Linux verwenden from which these instructions here were gathered.
Download Novell NVidia Packages
From
for NVidia.
Install these rpm packages.
Download NVidia driver
Go to your favorite nvidia website and look into the driver archives. Download the appropriate (!) driver version according to
- your pc architecture / kernel
- the corresponding driver version
Consider the downloaded rpm's above.
Go into a shell (Ctrl+Alt+F1) and switch to runlevel three:
init 3
Then install the NVidia driver
modprobe -r nvidia sh NVIDIA_XYZ.run -a -n
Using the parameter -a -n avoids the question about licence and matching online binary drivers. We don't need them because we are compiling the kernel ourselves.
Then - if everything went o.k. load the module:
modprobe nvidia
Now you can start sax2 to configure your xserver:
sax2 -m 0=nvidia
After you finished start your xserver by switching back to runlevel five:
init 5
Configure XGL as default Desktop
Look at
how to configure the sysconfig files.
Using YaST, you have to look at the bottom in the sysconfig editor to find the appropriate field.